Badge Resizing

The overall badge size can be adjusted, with some limitations.  This is achieved by clicking with the left button anywhere in the badge background area and selecting the  design toolbar button (or alternatively, right mouse button anywhere in the badge background area and select Edit Rectangle Parameters from the popup window).  The standard rectangle editing dialog will appear, as described in more detail below. 

In the sizing area to the lower right, only the X Size and Y Size fields are available, the X Position, Y Position and Auto Photo Size being grayed out.

The overall badge size can be adjusted by entering new values in either of the X Size and Y Size fields.  When OK is clicked the badge will be resized according to the values entered.  If the values increase the size of the badge, then all the data holders within it will be positioned in the center of the new area.  They can then be moved around as needed.

However, if the badge is reduced in size, the program will check that the new size can completely contain all the data holder rectangles.  If it can, resizing will continue.  If not, then a dialog will appear showing the minimum values which will fully encompass all the holders.  Clicking on Yes will accept these values, NO will allow you to re-enter them.

You can find the minimum badge size that will encompass all the holders by setting the two values to zero.  The program will then compute the actual minimum width and height that will encompass all the holders and offer those settings.  Clicking on Yes will set the badge to this minimum size.