MagTek USB Swipe Reader (P/N 21040140) Hex Commands for use with USB MSR Demo and Programmer ============================================================================================ Reader Mode =========== To set the reader into Keyboard Emulation Mode: 01 10 00 To set the reader into HID Mode: 01 10 01 Format and Track Selection ========================== Decode ISO/ABA - Track 1 ONLY: 01 03 01 Decode ISO/ABA - Track 2 ONLY: 01 03 04 Decode ISO/ABA - Track 3 ONLY: 01 03 10 Decode ISO/ABA - Tracks 1 & 2 ONLY: 01 03 05 Decode ISO/ABA - Tracks 1 & 3 ONLY: 01 03 11 Decode ISO/ABA - Tracks 2 & 3 ONLY: 01 03 14 Decode ISO/ABA - Tracks 1, 2 & 3: 01 03 15 Decode All Formats - Track 1 ONLY: 01 03 81 Decode All Formats - Track 2 ONLY: 01 03 84 Decode All Formats - Track 3 ONLY: 01 03 90 Decode All Formats - Tracks 1 & 2 ONLY: 01 03 85 Decode All Formats - Tracks 1 & 3 ONLY: 01 03 91 Decode All Formats - Tracks 2 & 3 ONLY: 01 03 94 Decode ALL Formats - Tracks 1, 2 & 3: 01 03 95 Reset Device (For after ANY settings changes) ============================================= 02 (OR power cycle by unplugging/replugging device) Notes on Hex Codes ================== 01 in first position indicates SET of a property 02 in first position indicates DEVICE RESET 10 in second position indicates INTERFACE TYPE (HID vs Keyboard) 03 in second position indicates TRACK ENABLE/DISABLE flag For more information and settings ================================= See the PDF file in the "USB Reader Configuration Documentation" folder