Adding A Photograph Holder

We will now add a photograph holder to our badge:

1.  Click on the  left side toolbar button

2.  Left button click and drag anywhere on the badge to create a white rectangle

3.  Left click on the rectangle and drag it to the desired position

4.  The rectangle you just created should still be selected.  If not, Left click on it. Click on the  left side toolbar button

5.  In the pop-up dialog select Photograph should already be selected from the pull-down in the Content Format section

6.  Click on the X Position text entry box and enter 0.20(5.1)

7.  Click on the Y Position text entry box and enter 0.20(5.1)

8.  Because photographs are traditionally 1” x 1¼” (25.4mm x 31.8mm), press the Photo Size button to immediately enter these values in the X and Y Size fields

9.  Click on OK

You should now have a correctly sized rectangle with the word Photo in it to remind you of its contents.

You may have noticed an “Inverted” check box in step 3.  If you check this, the photograph will be displayed up-side-down.